How to Measure Accurate EVM for a DUT in 5G NR Systems

Get quote
UXA Signal Analyzer
+ UXA Signal Analyzer
UXA Signal Analyzer
+ UXA Signal Analyzer

Measuring accurate EVM by suppressing system noise in 5G NR receivers

Measuring the true performance of the device under test (DUT) in 5G new radio (NR) receivers requires a test system that suppresses the system noise to get a lower error vector magnitude (EVM) floor at higher frequencies and wider bandwidths. The test system’s residual EVM noise floor must be low enough so it is not the dominant source of error, or so that it does not mask the DUT’s true performance.

The test system should include two signal analyzers with signal analysis software and be able to compare the measured EVM of the test system on each to mathematically remove the noise contributed by the test system. This method is called cross-correlated EVM (ccEVM) and provides an accurate and reliable DUT EVM measurement for 5G NR frequency range 1 (FR1) and FR2 applications.

Self-discharge measurement system

5G NR receiver test solution

Measuring accurate EVM for a DUT in a 5G NR system requires a test system that can suppress system noise. The Keysight 5G NR receiver test solution combines two N9042B UXA X-Series signal analyzers (spectrum analyzers) with N9085EM0E PathWave X-Series multi-touch application software. The cross-correlated EVM method compares the EVM measurements of the test system from each signal analyzer to remove the noise contributed by the test system. This enables you to measure the true performance of your DUT at high frequencies up to 110 GHz and wide bandwidths up to 4 GHz in 5G NR FR1 and FR2 applications and beyond.
Get quote

See demo of a ccEVM measurement for 5G NR receiver test

Explore products in our 5G NR receiver test solution

Related use cases

How to Emulate Non-Terrestrial Networks in the Lab
functional test

How to Emulate Non-Terrestrial Networks in the Lab

NTN test requires laboratory reconstruction of all possible NTN scenario permutations. Learn how to perform end-to-end testing and validation of NTN deployments.

Learn more keysight-arrow

How to Measure Noise Figure Using the Y-Factor Method
qa

How to Measure Noise Figure Using the Y-Factor Method

Measuring noise figure requires characterizing a receiver and its ability to detect weak incoming signals in the presence of self-generated noise. Learn how to use the Y-factor method to conduct noise figure and gain measurements.

Learn more keysight-arrow

How to Perform 6G FR3 System Test
qa

How to Perform 6G FR3 System Test

6G FR3 system test requires a channel emulator and software to perform phase and time coherent multichannel emulation using semi-deterministic and deterministic channel models.

Learn more keysight-arrow

contact us logo

Get in touch with one of our experts

Need help finding the right solution for you?

Contact us